How To Reset Cisco 2960 Switch To Factory Default

How To Reset Cisco 2960 Switch To Factory Default. The mode button should be on the left front of the switch, this is standard on all cisco switches. 4c:30:2d:81:ef:80 xmodem file system is.

Cisco Catalyst 2960 WSC296024TCS V02 Factory Reset 24Port 10/100
Cisco Catalyst 2960 WSC296024TCS V02 Factory Reset 24Port 10/100 from www.ebay.com

While holding down the mode button power on the switch. The mode button should be on the left front of the switch, this is standard on all cisco switches. Reset a cisco 2960 switch to factory default settings.

Reset A Cisco 2960 Switch To Factory Default Settings.

Using driver version 1 for media type 1 base ethernet mac address: Join ronnie to learn how to easily reset a cisco 3750 switch to its factory default settings with or without a password. First, power off your cisco 2960 switch by unplugging its cord.

Connect Up A Console Cable And Power On The Switch, Whilst Holding Down The “Mode” Button:

The lower three should flash, keep holding until the lower lights stop flashing, around 10 seconds. This tutorial will help you reset the cisco switch to factory defaults. Once you see the prompt, enter the following command:

This May Take A Few Minutes).

Connect your console cable and power up the cisco switch; In this example, i’ll be resetting a cisco 2960 switch. Resetting your cisco switch to factory defaults will allow you to configure it again as a new switch.

Hold It For About 15 Seconds Until The Sys Led Is Solid Green, And Then Release It.

Reset a cisco 2960 switch to factory default settings. Keep holding down the mode button! Hold down, and continue holding the mode button.

Power Off The Switch And Hold Down The Mode Button.

4c:30:2d:81:ef:80 xmodem file system is. Connect up a console cable and power on the switch, whilst holding down the “mode” button: The mode button should be on the left front of the switch, this is standard on all cisco switches.

Share This Post

Post Comment