How To Default A Cisco Switch Port

How To Default A Cisco Switch Port. Dg must have the proper routes to route such packets. Verify port security is enabled and the mac addresses of pc1 and pc2 were added to the running configuration with “show run” command.

Cisco Catalyst C3750X 48 Port POE Switch WSC3750X48PE 5 Year
Cisco Catalyst C3750X 48 Port POE Switch WSC3750X48PE 5 Year from www.tritondatacomonline.com

First, make sure the dg is on the same network. R1(config)#do show run int fa0/0 building configuration… current configuration : Until then the only way to reset a port would be to use all of the no versions of the commands, which i know can be a bit of a pain.

Type The Command “ Enable ” & Press Enter Key To Get In To.

Reset interface (port) to default. This indicates a successful connection. The default gateway is essentially the address of the router that the switch will be communicating with.

Backup—A Blocked Port In A Loopback Configuration;

The switch makes dhcp and rarp requests only if the sc0 interface ip address is set to 0.0.0.0 when the switch boots up. To configure a dg on your cisco switch: This puts the switch into configuration mode.

The Default Vlan Is Simply Stating What Vlan All The Ports Will Belong To In The Switches Default Configuration.

You can alter the boot system parameters with the boot command. Log on to your switch, and enter the privileged exec mode by entering enable and then entering the enable password command. Alternate—a blocked port providing an alternate path to the root bridge in the spanning tree;

The Switch That Has At Least One Of Its Ports In The Designated Role Is Called The Designated Switch.spanning Tree Forces Redundant Data Paths Into A Standby (Blocked) State.

The switch that has all of its ports as the designated role or as the backup role is the root switch. By default, port security is disabled on all interfaces. Reset interface (port) to default.

Type Configure Terminal And Press ↵ Enter.

At this stage, you want to assign a default gateway to the switch. To see all the ports on a router or switch you just need to run the command show ip interface brief. Changing the switchport access vlan x under the interface takes the access port out of the default vlan and puts it into the defined vlan.

Share This Post