How To Configure Cisco Access Point 2602. The ap then looks via dhcp for a management ip address like a standard ap. To enable the ap priority feature, follow these steps:
This guide provides instructions on how to install and configure your cisco aironet 2600 series. Posted on july 26, 2019 july 26, 2019 by danijuntak. Whilst holding the mode button, connect the power cable or.
5 4 Unpacking To Unpack The Access Point, Follow These Steps:
Point your web browser to the ap. In order to do this, navigate to network > network interface > choose the correct radio interface. Cisco ios configuration guide for autonomous aironet access points cisco ios release 15.3 (3)jab 20/aug/2014.
I Went To My Dhcp Server And Found The Ip Address That It Had Obtained:
4 Unpacking To Unpack The Access Point, Follow These Steps:
If any item is missing or damaged, contact your cisco representative or reseller. Step 2 click the ip address of the applicable controller. Convert the ap into a workgroup bridge from the default mode of the root ap.
The Contents Of This Chapter Are Similar To The Instructions In The Quick Start Guide That Shipped With The Wireless Device.
The cap in the model number says that it was shipped from cisco with the controller based software image. After flashing this default image the ap reboots into standalone mode and is ready to use. Step 2 enter the wireless device ip address in the browser address line and press enter.
Step 2 Return Any Packing Material To The Shipping Container And Save It For Future Use.
Some links below may open a new browser window to display the document you selected. Videos you watch may be added to the tv's watch history and influence tv. Step 1 unpack and remove the access point and the accessory kit from the shipping box.