Fortigate Trunk To Cisco Switch

Fortigate Trunk To Cisco Switch. Here is the config on the fgt attached to port fa0/7, please note it has no vlan configured, it is just the native untagged port. The fortigate unit can also forward untagged packets to other networks such as the internet.

Solved Best way to connect 3650 stack to Fortigate 300D HA Cisco
Solved Best way to connect 3650 stack to Fortigate 300D HA Cisco from community.cisco.com

I have a scenario setup with 2 separate. In this mode, the fortigate unit controls the flow of packets between vlans and can also remove vlan tags from incoming vlan packets. On the switch device we will configure port channel for 2 network ports running trunk with fortigate device.

On The Switch Device We Will Configure Port Channel For 2 Network Ports Running Trunk With Fortigate Device.

Here is the config on the fgt attached to port fa0/7, please note it has no vlan configured, it is just the native untagged port. Hardware is cpu interface, address is 000e.38ed.fa00 (bia 000e.38ed.fa00) internet address is 192.168.11.25/24. You need to tag the switch with the ap connected to it and route it to the core switch and then fortigate.

I Believe We Are Running Into Stp Issues Because The Fortiswitches Are Using Mst.

For the mode, select static, passive lacp,. I have a scenario setup with 2 separate. Also dhcp relay to assign ip address for each vlan to a.

The Interfaces To The Fw Are Access Vlan 4, Back To The Core The Interface Is Trunk.

In nat mode, the fortigate unit supports vlan trunk links with ieee 802.1q‑compliant switches or routers. The trunk interface on your cisco switch is will probably need to have the native vlan set. Enabling the switch controller on the fortigate unit.

Select Create New > Trunk.

The fortigate works like a more traditional router in this aspect. Go to wifi & switch controller > fortiswitch ports. To configure the aggregator mode for a fortiswitch managed by fortigate:

Enter A Name For The Mclag Trunk.

I have a 30e connected to a s4148t switch. So i needed to create two sub interfaces on the fortigate (on port3). Each interface you create is a separate network and has to be routed by the fortigate.

Share This Post