Command To Shutdown All Unused Ports On Cisco Switch

Command To Shutdown All Unused Ports On Cisco Switch. Free computer networking labs & study guide For example, if a catalyst 2960 switch has 24 ports and there are three fast ethernet connections in use, it is good practice to disable the 21 unused ports.

How To Basic Cisco Switch Configuration TDSheridan Lab from tdsheridanlab.com

(i.e, shutdown the ports) task: To display a status of an interface, use the 'show interfaces status ' command : The second command will give you a summary of.

To Enable The Switch Give Give Following Command:

If you are upgrading a switch, there is really no need to shut down all the ports. If a port later on needs to be reactivated, it can be enabled with the no shutdown command. If you do not configure the port to send only prestandard bpdus, the multiple stp (mstp) performance might diminish.

For Example, If A Catalyst 2960 Switch Has 24 Ports And There Are Three Fast Ethernet Connections In Use, It Is Good Practice To Disable The 21 Unused Ports.

Navigate to each unused port and issue the cisco ios shutdown command. Alternatively, you can enable the interface by negating the command using no shutdown. There is an interface range command you can use but that does not shut down all the ports at the same time.

I Will Show The Examples Of These Commands, As Well As How To Check An Interface Status Using The Show Interfaces Status Command.

Type the following commands to disable an interface on a cisco switch or router : Access port are the frames received on the interface are assumed to not have a vlan tag and are assigned to the specified vlan. Not sure if there is a command to shut down all ports on a switch.

You Could Syslog These Events To A Server And Roll Some Script To Correlate Down Vs Up Dates Per Port.

Cisco switch by default have all ports enabled (up). (i.e, shutdown the ports) task: S1 (config)# interface f0/5 2) shut down the port.

In This Ccna Certification Topic We Have Covered Switch Port Security.

The good point here is switchmap creates one file per switch. Make a list of interfaces, for each switch. Disable interfaces gi0/1 to g10/24 on switch7.

Share This Post