Command To Create Vlan On Cisco Switch

Command To Create Vlan On Cisco Switch. You cannot assign a previously created vlan. Vlan 1 is the native vlan of all cisco switches and it can not be changed, deleted, or renamed.

How to Configure VLAN on Cisco Switch Solutions
How to Configure VLAN on Cisco Switch Solutions from www.sysnettechsolutions.com

Let's test vlan 10 first. Switchport trunk allowed vlan add x. And a command like :

If You Want You Can Give It A Name But This Is Optional.

Similarly connect pc3 and 4 with fast ethernet 5 and 6 and pc 5 and 6 with fast ethernet 9 and. (optional) enter the show vlan command to see your changes. So let’s create them with the following commands.

Switch# Configure Terminal Enters Configuration Mode.

We have two vlan configurations vlan 10 and vlan 20. I.e all the ports in the switch will be connected to the. Access pc's command prompt to test vlan configuration.

You Can Change The Block Of 128 Reserved Vlans To Occupy Another Range Of 128 Adjacent Vlans.

It is importent that when you create a vlan in the vlan database you either type apply or exit. For example, you can change the reserved block of vlans to be 400 to 528. Operation 2 reads the main body of the file, which contains most of the domain and vlan information.

Vlan Vlan Batch 2 To 9 10 And Etc.

Vlan 1 is the native vlan of all cisco switches and it can not be changed, deleted, or renamed. In the picture above you can see that all of the 24. (optional) enter the following command to display information about a port:

In Vlan 10 We Have Three Pcs With Ip Addresses 10.0.0.2, 10.0.0.3 And 10.0.0.4.

First off, we need to enter configuration mode on the cisco 2960g switch. To crete a vlan at least in packet tracer i have to do it one by one repeating. Vlan 1 is by default the inband (sc0) interface of a switch.

Share This Post