Cisco Would You Like To Terminate Autoinstall

Cisco Would You Like To Terminate Autoinstall. You can delete the current startup configuration files and return the router to its factory default settings with the erase nvram: Complete router1# reload system configuration has been modified.

Cisco router basic configuration as follows
Cisco router basic configuration as follows from yoki-w.blogspot.com

But this is different than autoinstall. Configure the terminal emulation program for these parameters: 6 step 1 obtain this information from your network administrator before you start the setup program.

Type No And Press Enter.

Which command can you use to determine the cisco ios feature set on a cisco router? The cisco ios ios relea dependin. It seems like i can't get the would you like to terminate autoinstall message on the switch when i reloaded it with no config.

Would You Like To Terminate Autoinstall?

Autoinstall and setup are two different things. Yes system name:wlc2 enter administrative user. For more information on using the setup command facility, see the setup command chapter in cisco ios configuration fundamentals command reference,.

Would You Like To Terminate Autoinstall?

Would you like to terminate autoinstall: Ok starting portal server services: [confirm] [ok] erase of nvram:

You Must Assign A New, Unique Ip Address To Its Interfaces So That The Default Configuration File Can Be Used For Configuring The Next Router.

Initialize the switch and reload step 1: The wlc supports an autoinstall feature that lets you download a configuration file from a tftp server automatically. Enter administrative user name (24 characters max):

Start The Pc's Terminal Emulation Program.

Press return to terminate autoinstall and continue with manual configuration: Note if you make a mistake while using the setup command facility, you can exit and run the setup command facility again. Configure the terminal emulation program for these parameters:

Share This Post