Cisco Wlc Session Timeout Best Practice

Cisco Wlc Session Timeout Best Practice. Our cisco wlc is using 802.1x and ise is configured for peap with all inner methods enabled. The default value is 5 minutes.

vendor’s best practices
vendor’s best practices from dot11stream.com

If you have 10s of thousands then you should think about not changing it. Note when a 802.1x wlan session timeout value is modified, the associated client's pmk cache does not change to reflect the new session time out value. The catalyst wireless solution is built on three main pillars of network.

Note When A 802.1X Wlan Session Timeout Value Is Modified, The Associated Client's Pmk Cache Does Not Change To Reflect The New Session Time Out Value.

Cisco ise and wlc timeout best practices. I am fairly new to ise. There is a peap session timeout in ise, a session timeout on the wlc and a radius reauthentication timeout.

Even Active Clients Timeout And Reconnect Every 30 Minutes.

It's not an idle timeout, it's a session timeout. By default, this value is 7200 seconds, which is 2 hours. The only reasonable way i've found to monitor for a session timeout is to setup an asynchronous call to the server based on a javascript timer.

Restore The Configuration Including A Wlan With Psk.

The default value is 1800 seconds for the following layer 2 security types: I have yet to find any documentation regarding best practices of this value, but. Our cisco wlc is using 802.1x and ise is configured for peap with all inner methods enabled.

This Is Because The Event Is Occurring Over On The Server And Is Completely Separate From The Client Itself.

First off, when a session timeout occurs, the user will not immediately know. If you have 10s of thousands then you should think about not changing it. You can see session timeout of zero.

If You Have Hundreds Of Clients It's Probably Not An Issue.

Check the box to enable eap tls session resume and fill in a value for eap tls session timeout. Cisco wireless lan controller (wlc) configuration best practices introduction. Open again wlans > wlan1 > advanced 6.

Share This Post