Cisco Switch Add Static Route

Cisco Switch Add Static Route. To configure the gigabitethernet and serial interfaces of the cisco router, open the cli prompt and execute the following commands. Igmp (internet group management protocol) igmp version 1;

Static Route Configuration Route, Configuration, Static
Static Route Configuration Route, Configuration, Static from www.pinterest.com

By adding a static route, a router can be told how to send or forward packets to the subnets that are not directly attached. Configure a recursive static route. Use the following ios commands to open the fast ethernet interface fa0/0 configuration mode.

Open The Simulator Program And Configure The Tcp/Ip Settings Of The Computers After Creating The Network Topology As Shown In The Image Below.

Configuring static route on cisco asa firewall. When an interface goes down, all static routes through that interface are removed from the ip. Cisco vss (virtual switching system) cisco stackwise;

The Default Administrative Distance Of A Static.

Beginning in privileged exec mode, follow these steps to configure a static route: I added static route in cisco3550 series switch using ip route. command. Static routes are the most trustfull routes after directly connected interfaces for cisco devices.

We Will Demonstrate Adding Static Routes With The Help Of Two Routers, Router R1 And Router R2, And Three Subnets 12.0.0.0, 1.0.0.0 And 2.0.0.0.

Ip route x.x.x.x y.y.y.y z.z.z.z. How can i add a static route in cisco 2950 series switch? Configure a routing policy for static routing to be used for reliable static routing backup.

Configure A Recursive Static Route.

So, the administrative distance of static routes is 1. By adding a static route, a router can be told how to send or forward packets to the subnets that are not directly attached. Use the following ios commands to open the fast ethernet interface fa0/0 configuration mode.

The Switch Retains Static Routes Until You Remove Them.

Before cisco ios software release 12.0, this processing time was 5 seconds. Use the no ip route prefix mask {address | interface} global configuration command to remove a static route. When a static route is added or deleted, this route, along with all other static routes, is processed in 1 second.

Share This Post