Cisco Show Power Supply Status

Cisco Show Power Supply Status. Shows whether cisco express forwarding switching is enabled for the interface. The status led lights yellow.

Cisco PWRC454200ACV 4200W Power Supply (2)
Cisco PWRC454200ACV 4200W Power Supply (2) from www.dougdeals.com

One of the switches has an additional 1100wac power supply in slot b. (optional) displays the operational status of the power supplies. (both power supplies are required in the cisco.

Cefcfrupoweradminstatus.66531208 = On (1) Cefcfrupoweroperstatus.66531208 = On (2) Cefcfrucurrent.66531208 = 3000.

Once the issue has occurred, use the following procedure to replace the faulty psu. Cisco catalyst 9600 series switches offer combined and redundant configuration modes for power supplies. Determine which snmp oid to use.

65% Router#Show Platform Hardware Slot P1 Fan.</P>

Failed—the power supply has failed and should be replaced. Not present—the specified power supply is not installed. Ok—the power supply is operating normally.

When I Do A Show Power Inline, It Only Shows The 715Wac Power Supplies In Slot A Of Each Stack Member:

(optional) displays the operational status of the power supplies. For particular fex use # sh environment fex 101. (both power supplies are required in the cisco.

Can Anyone Explain What 1368.3 (Total Num Of 0/Pm0/*~0/Pm3/*) And Power Draw Indicate.

The status for each power supply is one of the following: The following example illustrates how to display the led status on a supervisor module. Configuration examples for internal power supplies.

Power Device / Form Factor:

Operational status of power modules. # after running the 3650 device for some days (7 days) the power supply status is not logged in logging buffer/syslog after the power cord is removed/connected back or oir is done for the power. The status led lights yellow.

Share This Post

Post Comment