Cisco Packet Tracer Router Configuration Step By Step

Cisco Packet Tracer Router Configuration Step By Step. Then note the port and slot numbers of the router’s gigabitethernet interfaces in the workspace. Controller dsl 0 mode atm exit example:

Step By Step Configuration Cisco VoIP Phone in Cisco Packet Tracer.
Step By Step Configuration Cisco VoIP Phone in Cisco Packet Tracer. from kirtikumarpatel.blogspot.com

After this command you are in enable mode. Router dhcp configuration with packet tracer. From global configuration mode you need to enter into interface configuration mode:

Command Purpose Step 1 For The Cisco 878 Model Only:

Type config t (configure terminal) to access the configuration menu. Add one cisco router, two cisco switches, and four pcs on the program’s workspace. To gain more experience on cisco cli, cisco packet tracer is the best tool especially for the beginners and the intermediate level.

When You First Power Up A New Cisco Router, You Have The Option Of Using The “Setup” Utility Which Allows You To Create A Basic Initial Configuration.

• type interface fastethernet0/0 to access fastethernet0/0 and configure the fastethernet0/0 interface with the ip address 192. Use admin for both the user name and password. #amartechstuff #ciscopackettracerthis video focus on router basic configuration in cisco packet tracerbest of luck !!!!check the blog :

After This Command You Are In Enable Mode.

This is an essential step in order for your router to be able to forward packets in the network. Connect to the wireless router connect to the wireless router configuration web page at 192.168.0.1 from pc0. You can use these cisco lab files for all your cisco certifications especially for cct, ccna, ccnp ( ccnp encor , ccnp enarsi) and ccie enterprise.

Enter Configuration Commands, One Per Line.

Now you can do any configuration on the cisco router. Select the router and open cli. To configure recursive static routes, use the following syntax:

Now The Router Is Configured Successfully And We Have Assigned Ip Addresses To The Router Interface Ports.

Drag and drop the device with the desktop view into the workspace in the right section. From global configuration mode you need to enter into interface configuration mode: Type enable to activate the privileged mode.

Share This Post