Cisco Layer 3 Switch Etherchannel

Cisco Layer 3 Switch Etherchannel. Modified 10 years, 6 months ago. And for layer 2 etherchannels, based on trunk state and.

Cisco and System Security Basics Lesson 24 Layer 2 Etherchannel
Cisco and System Security Basics Lesson 24 Layer 2 Etherchannel from ciscoiseasy.blogspot.com

A layer 3 etherchannel is similar to an interface on a router. Both the auto and desirable modes enable ports to negotiate with partner ports to form an etherchannel based on criteria such as port speed. I suddenly must configure two cisco switch 2960s within the same network, basically the idea is that through two cables they will physically be connected but logically, in each switch, two.

Assume Physical Interfaces Gi0/0 Up To Gi0/3 Will Be Used To Form An Etherchannel.

Starting at ‘1’ and using the same number on both sides keeps the configuration logical and easier to troubleshoot. Lacp 1:1 redundancy and dampening. Configure ip address 192.168.0.1/30 on switch1 and 192.168.0.2/30 on switch2.

Before We Configure The Port Channel Settings You Need To Make Sure That All Interfaces Have The Exact Same Configuration.

I am able to configure etherchannel on switch site as shown below: Switch ports exchange pagp packets only with partner ports configured in the auto or desirable modes. Both the auto and desirable modes enable ports to negotiate with partner ports to form an etherchannel based on criteria such as port speed.

Cisco Ios Xe Amsterdam 17.3.1.

And for layer 2 etherchannels, based on trunk state and. Viewed 4k times 0 1. So you will not be able to ping 10.204.96.3 on sw2 until you enable ip routing and add a static route.

This Chapter Describes How To Configure Etherchannels On Layer 2 And Layer 3 Ports On The Cisco Me 3800X And Me 3600X Switch.

The range for this command is 2 to 8. And for layer 2 etherchannels, based on trunk state and. Layer 3 etherchannel support on the cisco integrated services router.

Feature Support And Performance Consideration.

The switch won’t “switch” traffic on this interface but route it. Ask question asked 10 years, 6 months ago. A layer 3 etherchannel is similar to an interface on a router.

Share This Post