Cisco Default Interface Range Command

Cisco Default Interface Range Command. Cisco and juniper both have cli option to configure multiple interfaces within single line item. After separating with a comma, you need to specify the interface from.

Configuring LAG Settings on a Switch through the Command Line Interface
Configuring LAG Settings on a Switch through the Command Line Interface from www.cisco.com

Share tweet share pin it. Cisco ipsec vpn configuration examples. This one is the interface range command.

If You Have Multiple Interfaces That Need To Be Configured With The Same Settings, You Can Use The Interface Range Command To Specify A Range Of Interfaces To Which The Subsequent Commands Will Be Applied.

R1(config)#do show run int fa0/0 building configuration… current configuration : In global configuration mode, enter the following. Cisco and juniper both have cli option to configure multiple interfaces within single line item.

Dashes Separate Contiguous Interfaces And Commas Separate Noncontiguous Interfaces.

Interface range command on cisco router/switch. An enable mode command that displays the current configuration: An interface range cannot span slots.

For Example, Let’s Say That Interfaces Fa0/4, Fa0/5, Fa0/6, Fa0/7, And Fa0/8 Need To Have The Same Description.

What this command does is to select a range of interfaces and apply the same commands to them. So you can easily remove all the configurations for a particular interface by using the default interface command. To remove the configuration for that port, use the following command.

Reset Interface (Port) To Default.

Let say the port range is from 1 to 3. Apr 25, 2019 ccna study guide no comments. The cisco interface range command runs on all platforms that support cisco ios release 12.0(7)xe, release 12.1 e, and release 12.1(5)t.

The Catalyst 2950 Series Has Certain Differences With More Recent Models.

Configures the global egress lan port mtu size. To configure multiple switchports at the same time, we use the interface range configuration command. Just understand what the command does and you can change that variable to accommodate your goal.

Share This Post