Cisco Catalyst 2960-X Reset

Cisco Catalyst 2960-X Reset. Keep holding down the mode button! There is a document for this on cisco’s website called resetting catalyst switches to factory.

Cisco WSC2960X48LPSL Catalyst 2960X 48Port 4 x 1G SFP LAN Base
Cisco WSC2960X48LPSL Catalyst 2960X 48Port 4 x 1G SFP LAN Base from www.northlandusa.com

Connect up a console cable and power on the switch, whilst holding down the “mode” button: Hold down the mode button on the front of the switch. The process is very simple:

Quite Basic Process To Reset A Cisco 2960G Switch Back To Factory Defaults If You Don’t Know The Passwords Of The Switch:

In cisco ios, whenever you enter a configuration command it takes effect immediately and goes into the 'running configuration'. In this video i reset the password and recover the old configuration of a production cisco catalyst 2960 switch step by ste. Hold down the mode button on the front of the switch and power it up 3.

Power On The Switch And Ensure No Ethernet Cables Are Plugged Into.

Hold down the mode button until you see the following output: Connect to the switch via console cable and make sure the connection is established. Hook up a console cable to the console port and use putty or other serial client to view the console session 2.

This Interrupts The Boot Process Before The Flash File System Can Initialize, And After A Short While You Will See The Following Prompt:

Connect up your console cable and power on the switch, whilst holding down the “mode” button: The biggest problem most people have with doing a password recovery on a 2960 or 3560 is knowing how long to hold the mode button down for. Enter “enable” mode by typing:

This Will Set That Particular Command To The Factory Default.

You can also use the default command within interface configuration mode. At first, i was a little bit lost due to a large amount of information scattered all. By default, a switch poe port automatically provides power when a.

Keep Holding Down The Mode Button!

There is a document for this on cisco’s website called resetting catalyst switches to factory. Connect up a console cable and power on the switch, whilst holding down the “mode” button: When the syst light stops blinking.

Share This Post