Cisco Air-Ap1041N-A-K9 Factory Reset

Cisco Air-Ap1041N-A-K9 Factory Reset. The enable password is not reset, i tried cisco but it doesn't work. It wouldn't respond to pings.

Cisco AIRAP1041NAK9 Networking Wireless Wireless 300MBPS New
Cisco AIRAP1041NAK9 Networking Wireless Wireless 300MBPS New from www.allhdd.com

Step 2 press and hold mode button. Including the ip address, to factory defaults. Click on the factory default button.

The Second Option Is Especially Handy In Case You Are Required To Perform This Procedure Remotely.

Including the ip address, to factory defaults. Reset or alternatively the reset to defaults (except ip) if we wish to reset to factory defaults but keep the current ip address. Scroll down to the ap details section and select the tools tab.

I'm Actually Working On My Ccna For Routing/Switching Right Now.

I have no experience with cisco whatsoever. I receive the following message after releasing the button: 3 hold the mode button until the status led turns amber (approximately 10 to 12 seconds), and release the button.

I'm New To This Group And Not Very Well Versed Yet In Cisco Wireless Equipment.

Someone offered me a couple of wireless ap's that they had no use for, so i figured it couldn't hurt to get in some practice with wireless. Supported mode (s) of operation: Button pressed for 9 seconds.

Reset To Factory Settings Using An Open Paperclip

Which mean i can't get any help from cisco. Step 2 press and hold mode button while you reconnect power to the access point. Then after the ap boots, i try to enter into enable mode, but the cisco password doesn't work.

When Router Is Powered On, Press The Reset Button And Hold For 30 Seconds.

The enable password is not reset, i tried cisco but it doesn't work. Step 1 disconnect power from access point. Factory reset cisco access points.

Share This Post