Cisco 3850 Stack Priority Configuration

Cisco 3850 Stack Priority Configuration. So please tell me the best configuration guide/steps for stacking the switches and also tell me the c I´ve two 3850 switches stacked.

Cisco 3850 Stack cabling and config Cisco Community
Cisco 3850 Stack cabling and config Cisco Community from supportforums.cisco.com

I´ve two 3850 switches stacked. Their switch priority are 15,14,13, and 12 respectively. Switch (config) switch 2 priority 8.

I´ve Two 3850 Switches Stacked.

Get out of configuration mode. View solution in original post. Switch priority can be done in enable or exec mode.

For Information About License Levels, See The System Management Configuration Guide (Catalyst 3850 Switches).

So please tell me the best configuration guide/steps for stacking the switches and also tell me the c We will configure the priority value with this commands: Their switch priority are 15,14,13, and 12 respectively.

Question Regarding A Cisco 3850 & Stack.

The hardware and software architecture of the cisco catalyst 3850 switch allows you to insert new cisco catalyst 3850 switches in a stack ring without major network disruption. Adding a switch to the stack. Cisco 3850 stack power cables.

Switch (Config) Switch 2 Priority 8.

You configure the priority values of each switch in the power stack and of all high and low priority ports on that switch to set the order in which switches and. Do you want to continue?[y/n]? You configure the priority values of each switch in the power stack and of all high and low priority ports on that switch to set the order in which switches and ports are.

Device # Device # Device 1 Role Active Warning:

If you try to configure the same priority value on different switches in a power stack, the configuration is allowed, but you receive a warning message. As the stack mac after a master switchover. I have a stack of 3850 that i am trying to set the stack member priority value.

Share This Post